PlumbRevise
Hot Water (L3)

Diagnosing hot water faults

Note 10 of 12 · free to read

A systematic approach to common stored hot water defects and how to reason from symptom to cause.

Reasoning from symptom to cause

Confirm the symptom, take the relevant measurements and use the manufacturer’s fault procedure to distinguish possible causes before selecting a repair. For component work, follow the specified isolation, cooling, depressurising and draining sequence. An overheating emergency needs its own response: on the unvented models considered here, T&P discharge calls for switching off heat input while leaving the water supply and relief route available, then obtaining competent help.

Common symptoms and likely causes

  • No hot water at all. First distinguish no outlet flow from normal flow at a low temperature. Supply isolation, a blocked strainer or an airlock can affect flow; heat-source, control or element faults can affect heating.
  • Water not hot enough. Check measured storage and outlet temperatures, settings, demand, useful heat input and any mixing valve. A low outlet reading does not mean the whole store is cool.
  • Slow recovery. Compare the temperature rise and actual heat input with the rated conditions. Low primary temperature or flow, restricted heat transfer, scale and control operation are possible causes. Running out during heavy use points first to capacity or demand; check recovery separately.
  • Discoloured or smelly water. Compare hot and cold samples and investigate the supply, deposits, materials and stagnation. Check a sacrificial anode only where the cylinder design has one; appearance or smell does not identify a single failed part.
  • Noises, banging or kettling. Scale on the heat transfer surface causing local boiling, or trapped air.
  • Unexplained relief discharge. Identify which valve operates, when it happens and the actual pressures and temperatures. Check the specified expansion provision, inlet pressure control, valve seating and temperature controls as indicated by the evidence.

Putting it right

Rectify the confirmed cause using the applicable service procedure. A cut-out must not simply be reset without investigating why it operated. After repair, repeat the required checks and record the work. Keep the relief route unobstructed throughout; stopping the visible drip by defeating a safety device leaves the hazard unresolved.

TMVs, circulation loops and sensors

  • For an unstable or incorrect TMV outlet temperature, check inlet temperatures and working pressures, required flow, strainers and the commissioned setting. Compare each with the model’s limits. The cause may be the supply, the installation or the valve itself, and the symptom does not tell you which is most likely.
  • Test the TMV safety response using its specified conditions and acceptance limits. Loss of the cold supply must not pass the full hot supply to the user; a permitted residual flow must meet the model’s temperature limit.
  • On a secondary loop, compare the individual branch returns. A high common return can conceal poor distribution to a remote branch. Check balance, pump duty and direction, air, restrictions, heat loss and supply temperature against the design; follow the pump’s safe filling and venting instructions.
  • Fit a thermostat or sensor probe in the specified position with proper thermal contact. A poorly seated sensor can respond slowly or report an unrepresentative temperature; verify it against the actual measured conditions.
  • Never cap a discharge pipe to stop dripping. A discharging relief valve may be working correctly and reacting to a problem elsewhere, such as lost expansion provision. Check that before blaming its seat. Keep the termination clear and protected against frost obstruction.