Trade-offs between heating water on demand and storing it in a cylinder.
Heat on demand or heat and store
Instantaneous. An instantaneous combi, multipoint heater or continuous-flow unit heats the domestic water during draw-off. There is no hot-water storage cylinder to empty, and standing losses are generally low. Some appliances keep a heat exchanger warm between draw-offs to reduce the delivery delay; this preheat function uses energy. The limit is flow rate: the available power must lift the incoming cold water to the delivery temperature, so the colder the inlet or the higher the demand, the lower the usable flow. Serving several outlets at once can stretch a single instantaneous source.
Stored. A cylinder provides a hot-water reserve and may continue reheating during as well as between draw-offs. It can support high peak demand when the supply and distribution are adequate. Compare usable volume, recovery at the actual operating conditions, simultaneous flow and standing heat loss: fitting a cylinder does not guarantee delivery performance.
Picking between them
- Simultaneous demand: many outlets at once favour storage.
- Space and standing loss: instantaneous saves the cylinder and its losses.
- Continuity: storage rides through short peaks; instantaneous never empties but caps flow.
An instantaneous combi is a common choice, while a storage combi includes a hot-water store. Each appliance should be installed and commissioned to the relevant boiler installation standard and the manufacturer instructions. Confirm flow rates and sizing against the design demand rather than a rule of thumb.
How a cylinder holds its heat
Hotter water tends to form an upper layer above cooler water. Use the model’s specified feed, draw-off and return connections to preserve its intended temperature profile. A wrongly positioned connection can disturb that profile and reduce useful delivery, but a full cylinder does not inevitably become lukewarm.
An instantaneous combi can suit modest demand, with several outlets sharing its available useful output. Check their flows and the required temperature rise: there is no fixed one-outlet rule. A storage combi includes a reserve and needs its own performance assessment.