Using manufacturer instructions, the Benchmark scheme and MCS standards as primary information sources.
Manufacturer instructions come first
For any specific appliance the manufacturer installation and servicing instructions are the primary source. They give the exact sizing data, clearances, flue options, water-quality limits, commissioning sequence and service routine. Use the correct model and revision for appliance-specific details, and check the applicable legal requirements as well. Manufacturer instructions do not override the law. Resolve a conflict with the manufacturer or relevant authority before proceeding; warranty conditions are a separate matter.
Benchmark
Benchmark is the industry commissioning and service record scheme for domestic heating and hot water. The completed checklist records the actual commissioning checks and results. It supports handover and is often part of the warranty requirements, but filling it in does not make an unchecked installation correct. The same logbook records later annual services.
MCS
The Microgeneration Certification Scheme (MCS) sets the design and installation standards for small renewable heat sources such as heat pumps and solar thermal. MCS-certified installation is normally required for grant funding and gives the customer a quality and consumer-protection framework. Heat-pump design in particular leans on MCS methodology for heat loss and emitter sizing.
Design guides and helplines
Recognised heating design guides and manufacturer technical helplines fill in detail — air-change rates, correction factors, pump and pipe data. Always cross-check that any figure you use is current, because standards and product data are revised regularly.
Keeping the design basis, not just the commissioning figures
A commissioning record shows what the system was set to on the day. Keep the design basis alongside it — the heat-loss figures for each room, the design flow and return temperatures, and the emitter and pipe sizes chosen from them — because that is what later work actually needs. These retained figures let a future engineer compare measured operation with the intended duty when investigating comfort, energy use or an alteration. Check present conditions as well: changes to the building, emitters or controls may require an updated design rather than restoration of an old setting.